Combined lubrication (Combined Lubrication System) is the mainstream lubrication setup adopted in modern internal combustion engines. Rather than relying on a single method, it integrates pressure lubrication, splash lubrication, and grease lubrication (for specific auxiliary bearings) into a complementary system. Its primary role is to deliver precise, on-demand lubrication based on the varying needs of internal engine components for lubrication intensity, flow rate, and heat dissipation—boosting overall efficiency while ensuring exceptional mechanical reliability.

A combined lubrication system operates much like a precision distribution centre, allocating engine oil according to the working loads of different components:
Pressure Lubrication Zone (Critical Load Areas):
Components: Crankshaft main bearings, connecting rod big-end bearings, and camshaft journals/bearings.
Operating principle: Serving as the engine's "intensive care unit", it relies on the engine oil pump to supply continuous high pressure, establishing a stable hydrodynamic oil film across metal contact surfaces to support the vast majority of mechanical loads.
Splash Lubrication Zone (Auxiliary Lubrication and Thermal Management):
Components: Cylinder walls, gudgeon pins (piston pins), and the valvetrain (valve tappets, pushrods).
Operating principle: It utilises the fine oil mist thrown off by rotating assemblies to lubricate hard-to-reach areas outside pressurised oil galleries. This approach ensures thorough coverage within the engine crankcase while reducing parasitic drag on the oil pump.
Targeted Jet Spray (Enhanced Cooling):
Components: Underside of piston crowns.
Operating principle: An extension of the pressurised circuit, dedicated piston cooling jets squirt high-pressure engine oil directly into the piston undercrown to rapidly draw away intense heat generated within the combustion chamber.
Because multiple lubrication methods are integrated, troubleshooting faults requires a methodical approach:
Pressurised circuit failure (Diagnosis): A loss of pressure typically results in bearing knock or an illuminated low oil pressure warning light, indicating a severe systemic fault.
Insufficient splash lubrication (Diagnosis): If the engine suffers from severe oil burning (excessive oil consumption) or cylinder bore scoring despite normal oil pressure readings, the crankcase airflow pathway is often restricted, preventing the oil mist from properly coating the cylinder walls.
Clogged cooling jets (Diagnosis): If piston cooling jets become blocked by contaminants or sludge, the pistons can overheat and expand excessively, causing the classic symptom where the engine runs smoothly when cold, but loses power or produces knocking noises once warmed up.
Engine oil viscosity matching: Combined systems require a finely balanced oil viscosity. It must not be too thick (which impairs splash atomisation) nor too thin (which compromises oil film strength under pressure). Adhering strictly to the factory Owner's Manual is the gold standard.
Importance of PCV maintenance: The Positive Crankcase Ventilation (PCV) system is vital to system health. If crankcase ventilation is compromised, excessive internal pressure disrupts the distribution of splash oil mist and can accelerate engine oil emulsification.
Engine flushing precautions: When using engine flush additives, ensure the chemical solvent effectively breaks down oil sludge without degrading rubber oil seals and gaskets, given the intricate internal sealing layout of a combined lubrication system.
Driven by increasingly stringent emissions regulations, combined lubrication systems are moving towards active electronic control:
Variable-stage pressure regulation: Through ECU-controlled solenoid valves, the system lowers oil pressure during low-load driving to cut parasitic losses, ramping up pressure under heavy loads to deliver full lubrication protection.
Ultra-low viscosity compatibility: Through technologies like nano-ceramic friction modifiers, ultra-low viscosity oils (such as 0W-8) can still maintain sufficient boundary lubrication across all critical friction pairs in a combined lubrication layout.