A PTC (Positive Temperature Coefficient) heater is an electric heating device that utilizes the properties of semiconductor thermistor ceramic materials to generate heat efficiently. Unlike conventional heating elements (where electrical resistance increases linearly or remains largely constant as temperature rises), the defining characteristic of PTC materials is that their resistivity increases drastically in a step-like manner as their temperature climbs. In modern New Energy Vehicles (pure electric vehicles and plug-in hybrid electric vehicles), which lack the substantial waste heat produced by traditional internal combustion engines, cabin climate heating and low-temperature traction battery preheating rely almost entirely on PTC heaters. It serves not only as the primary heat source for cabin warming and windscreen demisting/defrosting during cold weather, but also as a critical hardware component for rapidly preheating the traction battery in freezing conditions, ensuring optimal low-temperature charging power and discharge performance.
The hardware architecture of a PTC heater primarily comprises PTC ceramic heating chips, corrugated aluminium heat dissipation fins, high-voltage electrode pins, thermally conductive insulating silicone pads, and an external housing control circuit (including high-voltage relays and PWM control modules):
Positive Temperature Coefficient Step Temperature Control and Self-Limiting Property:
When high-voltage electrical energy is supplied to the PTC chip, the electric current passing through the semiconductor ceramic generates heat rapidly. As the chip's temperature rises, its internal resistivity increases exponentially; once it reaches the designated Curie temperature design point, the current automatically drops sharply. This physical characteristic provides the PTC heater with an inherent "self-limiting" thermal safety feature—the higher the temperature, the lower the heating output, fundamentally eliminating the risk of burnout or open flames caused by overheating.
Multi-Layered Corrugated Aluminium Fin Heat Exchange and High-Voltage Air Duct Integration:
Structurally, the PTC chips are sandwiched tightly between multi-layered corrugated aluminium fins with high thermal conductivity. A high-output blower fan forces recirculated or ambient air through the dense aluminium cooling fins, instantly converting electrical energy into a continuous stream of warm air delivered into the cabin. Meanwhile, in the battery thermal loop, a coolant-based liquid PTC heater (High Voltage Heater, or HVH) heats the coolant, which is circulated by a pump to transfer heat to the traction battery pack, enabling precise temperature regulation within the thermal management system.
Strictly Prohibit Operating the PTC Heater When High-Voltage Circuit Insulation is Damaged, Moisture Ingress Occurs, or Control Relays Suffer Contact Sticking/Welding:
PTC heaters are typically connected directly to the vehicle's high-voltage DC bus (several hundred volts) as high-power electrical loads. Never turn on the cabin heating if a coolant leak allows fluid to drip directly into the high-voltage PTC unit; moisture and conductive fluids can cause high-voltage short circuits to ground, instantly puncturing insulation layers and triggering severe electrical arcing or tripping the vehicle's main high-voltage fuse.
Strictly Prohibit Prolonged Full-Power Operation of Dry-Heating Air PTCs When the Blower Motor Fails or Air Ducts Are Severely Blocked:
Although PTC heaters feature self-limiting temperature characteristics, continuous dry-running under extreme conditions (such as the absence of airflow to dissipate heat) will cause localized temperature spikes, carbonizing and degrading insulation materials or accelerating the melting of adjacent plastic HVAC ducting. Never leave the heater running for prolonged periods if airflow fails completely or the blower fan does not run; the air conditioning blower system must be serviced promptly to prevent thermal hazards.