English
Download App
Follow Us
  • Facebook
  • YouTube
  • Instagram
  • TikTok
  • X
HomeNewsWashing your car after leaving it in the Malaysian sun? Here's why you should wait before reaching for the hose

Washing your car after leaving it in the Malaysian sun? Here's why you should wait before reaching for the hose

Your car has been baking in the Malaysian sun all afternoon. You finally get home, grab the hose and think a quick wash will cool it down and get rid of the dust. Sounds harmless enough, right?

Not quite. Washing a car while its bodywork is still scorching hot can cause a few problems, from stubborn water spots on the paintwork to potential damage to the glass. Hot brake discs also need time to cool before you spray them with water.

So, should you wait until your car has cooled down before washing it? And how can you tell when it's ready? Here's what Malaysian drivers should know.

What happens?

Windscreen: Sudden temperature changes can cause cracks to spread

After hours under the afternoon sun, a car's windscreen can reach temperatures of 60°C to 70°C. Pouring cold tap water over it causes the outer surface to cool rapidly, while the inner layers remain hot. This uneven temperature change creates stress within the glass.

If the windscreen already has a small chip from a stone impact, the sudden temperature change could cause the damage to spread into a much larger crack, potentially requiring a full replacement.

Paintwork: Water spots become harder to remove

Prolonged exposure to strong sunlight heats up the paintwork and can soften its clear coat. Although rinsing a hot car does not normally cause the clear coat to crack, repeated exposure to harsh conditions can take its toll on the finish. Over time, neglected paintwork may lose its shine and become more prone to deterioration.

There is another problem: water evaporates much faster on a hot body panel. Minerals left behind as the droplets dry can form stubborn water spots, which are particularly noticeable on darker paint finishes.

Brake discs: Avoid spraying them when they're hot

Brake discs can become extremely hot after a long drive or repeated heavy braking. Directing cold water from a pressure washer onto hot discs can cause rapid temperature changes and, in some cases, thermal distortion.

Damaged or uneven brake discs may cause steering wheel vibrations, brake judder or unusual noises when braking.

When is the best time?

Before getting started, use this simple one-touch, two-check approach to decide whether your car is ready for a wash.

Touch: Try the back-of-the-hand test

Gently touch the bonnet or roof with the back of your hand, which is more sensitive to heat than your palm.

If the surface feels uncomfortably hot and you cannot keep your hand there for more than two seconds, give the car more time to cool down. Ideally, the bodywork should feel only slightly warm or close to ambient temperature before you start washing.

Check the time: Avoid the hottest hours

In Malaysia, early morning before 9:00 AM or late afternoon after 5:30 PM are generally better times to wash your car.

Try to avoid washing it between 11:00 AM and 4:00 PM, when sunlight and surface temperatures are usually at their highest.

Check the location: Find some shade

Always wash your car in a shaded area if possible. If you've just driven it out of direct sunlight and into a car wash bay or garage, allow the bodywork to cool naturally before spraying it with water.

Three more ways to protect your car

Let the cabin cool down too

While waiting for the exterior to cool, open the doors to let hot air escape from the cabin. This helps reduce the temperature difference between the interior and exterior of the windscreen.

Dry the car instead of letting it air-dry

Once you've finished washing, use a clean microfibre towel to wipe away the remaining water droplets. Pay particular attention to darker paintwork, where mineral deposits and water spots are easier to see. Don't leave the car to dry naturally under direct sunlight.

Give the wiper blades a quick clean

Dust and fine grit can collect on wiper blades after prolonged exposure to the sun. Wipe the rubber edges with a damp cloth during your wash to remove the dirt and help prevent it from scratching the windscreen when the wipers are next used.

Follow Facebook

BitAuto.my 206.4K followers

Your go-to source for all things automotive in Malaysia. 🚗 Latest reviews, breaking news, launches & industry trends.

+ Follow

Get the latest car news first!

BitAuto.my

Your go-to source for all things automotive in Malaysia. 🚗 Latest reviews, breaking news, launches & industry trends.

206.4K followers + Follow
BYD's Flash Charging technology is finally here, with Denza Balakong being the first outlet to feature the "Ready in 5, Full in 9"-capable chargers. More Denza outlets will be receiving the Flash Charging technology, with the Glenmarie and Old Klang Road outlets being next. #BYD #Denza #FlashCharging 1 minute ago The updated 2027 Denza D9 is here, now equipped with BYD's Flash Charging Technology! Ready in 5 min, Full in 9 min! #Denza #DenzaD9 1 minute ago GWM Malaysia is giving away a brand-new Ora 5 Hi2 HEV! 🎁🚗 Celebrate GWM’s 4th anniversary with Good Cat deals from RM 94k, RM 17,000 H6 HEV perks, and 5 years free maintenance until 31 Dec. Full details here 👇 1 minute ago
Back to top
Feedback